How To Solve The Poor Cooling Effect Of Industrial Air Conditioners



Industrial air conditioner is a special tool for temperature reduction. It can be applied to industrial air conditioners in many scenarios. For example, it can be used in factory workshops to prevent heatstroke from high temperature for actual operating staff, and it can also be used to reduce temperature of machinery and equipment. Ensure that all machinery and equipment are operating normally. But sometimes, I find that the cooling effect of industrial air-conditioners is not good. What is going on? How to solve it?

How to solve the poor cooling effect of industrial air conditioners

1. Over-temperature maintenance of the refrigeration compressor causes the switching power supply to be disconnected. When the industrial air conditioner is in use, the operating voltage is too low or too high, and the operating temperature is too high, which will cause the refrigeration compressor of the industrial air conditioner to over-temperature load. In order to better maintain the refrigeration compressor, the thermal overcurrent protector will Posture, disconnect the switching power supply of the refrigeration compressor. At this time, when the industrial air conditioner is in the over-temperature and over-voltage protection device position, the industrial air conditioner is not easy to cool, and only blows out the air. If the thermal overcurrent protector is in constant position, remember not to start it frequently, and apply the industrial air conditioner after searching and clearing. It is the key reason why industrial air-conditioners will not be cooled due to power failure.

2. Common failures caused by clogged filter. Like traditional central air conditioners, industrial air conditioners have filters at the air inlets. If the filter screen contains dust, dirt, etc., it will harm the air intake and exhaust flow of the air conditioner, which is very easy to cause the heat exchanger to frost and cause common failures of the equipment. If this is a problem, you must pull out the filter, use a vacuum cleaner to remove the dust on the filter, and then clean it up with tap water, and apply it after it is completely dry. It is also important to note here that when cleaning the filter, do not use paint thinner, cinnamaldehyde, drugs, etc., as this will damage the filter and the surface of the industrial air conditioner.

3. Application of non-standard switching power supply extension cords leads to common failures. Industrial air conditioners can use switching power supply extension cords, but there are certain regulations for switching power supply extension cords. If the extension cord is too long. If the size is too small, the working voltage will be reduced and the equipment will not be able to operate normally, causing common failures of the air conditioner.

The working principle of industrial air conditioners is similar to traditional central air conditioners. It is a mobile air conditioner that enhances the traditional design concept. It is small and exquisite, has high energy efficiency, does not need to be installed, and can be placed at different addresses. If the cooling effect of the industrial air conditioner is not good, you can find the reason for the poor cooling effect according to the traditional central air conditioner, or find the treatment method according to the method I described.



Inquire Now!